Recently I was asked to renovate the tile and grout of this windowless bathroom in a Beckenham flat which was not looking its best. The Ceramic tiles had become dull due to a build up of Limescale and the grout had become stained from shampoo dyes and mould.
Without strong ventilation and regular cleaning most bathrooms can end up with these problems however with the right products and techniques they can be renovated as you will see below.
Deep Cleaning Bathroom Tile and Grout
My first action was to apply a liberal amount of Tile Dr Oxy-Gel which is a strong alkaline tile and grout cleaning product that comes in a gel form. Being a gel it’s able to sticks to vertical surfaces for longer allowing it to break down the Limescale and soap residue that had taken up residence. Once it had been left to dwell for around thirty minutes, it was scrubbed off with water and a pan scrapper and then dried with a micro cloth. You can use this process with glazed ceramic tiles like these but for natural stone I would have used a different approach.
I then sprayed Tile Doctor Duo Clean, which is a grout cleaner and mould remover, onto the grout lines. I left the grout with the Duo Clean on it for about ten minutes before scrubbing and rinsing off with water.
The process was repeated where needed until I was happy that the tile and grout were as clean as possible however to really give the bathroom a fresh look I decided to completely renovate the grout with the application of a Grout Colourant.
Grout Colouring Bathroom Wall Tiles
There are ten colours to choose from in the Tile Doctor range of Grout Colourant’s and in this case I felt the best outcome would be to use a White colourant to match the tiles and restore the original look of the bathroom; the customer however wanted a grout colour that would provide a contrast against the white tiles, so in the end we opted for a light grey colour.
The colourant is easily applied directly to the grout and in this case I waited for the tiles to dry before applying two coats with the aid of a small brush making sure to remove any excess that comes into contact with the tile.
I finished the renovation by cutting out the original mastic sealant from around the bath and replacing with a new mould resistant silicone in white to match the bathtub.
The bathroom now looks transformed and the epoxy grout colourant adds a layer of protection to the grout that will keep it looking good for some time to come.
Source: Bathroom Tile Cleaning and Restoration Service in Kent
We often get asked to do bathroom refresh and end of tenancy tile cleans however it’s a good job I’m not squeamish as this ceramic tiled shower cubicle was in a bad way.
The property was in the historic village of Herstmonceux in the Wealden District of East Sussex and apparently it had been leased to students who it seems were averse to cleaning, no surprise there.
Cleaning Ceramic Tiled Shower Cubicle
The first step was to remove the plastic product holder to expose the tile and grout, which revealed more staining and black mould.
With that removed I sprayed the Tile and Grout with Tile Doctor Oxy-Gel which works better than liquid products as being gel based it sticks to the wall tile and grout and really gets to work breaking down the dirt. I left this for a few minutes before scrubbing it and then rinsing it off with water. I had a problem with a patch of grout which was beyond cleaning and concerned it was going to upset the whole job I raked out it and applied new grout.
Grout Colouring Shower Wall Tiles
With the tiles now clean and fresh grout dried the next step was to apply a White Grout Colourant to ensure all the grout had a consistent appearance. Although time consuming the grout colourant is easily applied with a small brush and then you wipe off any excess that gets onto the tile.
The next step was to strip out the mastic silicone sealant strip from around the base of the shower cubicle and replace with new. I used high quality silicone sealant that left nice lines and fresh look, don’t use cheap sealant as it will soon discolour and some have been known to shrink.
Last step was to replace the plastic product holder which had been cleaned.
Quite a difference I think you’ll agree. Future cleaning advice was left with the customer; I just hope he passes it onto the next tenant.
Source: Stained Ceramic Tiled Shower Cubicle Refreshed in East Sussex
It’s not unusual for Shower tile and grout to become stained due to the dyes that are found in soap, mould can also be a common problem but usually this is down to inadequate ventilation. Whilst we do sell products that can keep your tile and grout clean we are also able to assist when a really deep clean is required. The photographs below are a great example of this and are of one of three shower cubicles we were asked to clean and restore at a modernised Victorian property in Sale, Cheshire.
Cleaning Ceramic Tile and Grout
We started by spraying the tile and grout down with Tile Doctor Pro-Clean which is a strong alkaline cleaner, spraying it on mixes it air which helps it to stick to Vertical surfaces allowing it to get to work on the dirt. We left it to dwell for ten minutes before scrubbing it in by hand using a stiff grout brush; this process certainly improved the grout but unfortunately it had become too badly stained to be satisfactory so we decided to recolour the grout using a white grout colourant.
To get the wall tiles and shower glass clean we sprayed on Tile Doctor Oxy-Pro, again leaving it to dwell for a while before gently scrubbing it away with water. Once dry we set about stripping off the silicone strip around the base of the shower wall which was stained and impossible to get clean again.
The grout colourant comes in a tube and is very straightforward to apply although I must admit the work is quite tedious. Two coats of white colourant were required to get the uniform appearance needed and I think you will agree the effect is quite transforming. The other advantage of these particular colourant products is that they are epoxy based and form a barrier of the grout preventing future staining and making it very easy to clean going forward.
The last step was to apply new silicone along the base of the cubicle and give the tiles a quick buff.
I think you will agree it was quite a transformation and the cubicle now looks like it was recently installed.
Source: Restoring the Appearance of Shower Cubicles in Cheshire
Here’s a quick example of an interesting tiled shower cubicle at a property in Edinburgh that was well overdue for a refresh, including deep cleaning and recolouring do the grout lines that had become stained and mouldy. This is a problem that the majority of property owners experience due to the simple fact that shower cubicles come into contact with damaging acid-based shampoos and soaps on a daily basis.
The short-term solution for this is to wash the shower cubicle down with water after each use, however busy people do not always remember to do so! The prognosis is bad discolouration, mould growth and staining if the problem if proper care isn’t taken. In this case, the problem had worsened to the point that the property owner decided to contact Tile a Doctor to provide a thorough refresh of the tiles.
Cleaning Stained and Discoloured Shower Cubicle Tiles
Our process for refreshing shower cubicles in a similar state to this one is simple, but highly effective. I started by mixing a strong solution of our high alkaline cleaner, known as Tile Doctor Pro Clean (diluted to an appropriate level with water), before applying it directly to the tile and grout.
Next, I worked it in using specialised handheld grout brushes , with the alkaline in the Pro Clean neutralising the acidic staining and mould growth had leaving the area clean and fresh. Pro Clean is suitable for use on all kinds of natural stone, and on both verticals and horizontal surfaces. Once satisfied the grout had been cleaned to the best of my abilities, I quickly dried the entire area using a heat gun.
Recolouring Shower Cubicle Grout
To restore the appearance of the installation back to it’s optimal appearance I chose to recolour the grout lines with our Light Grey grout colourant, which matched in very nicely. This is just one of ten different colours of grout colourant we offer. The colourant was left to dry for a short period before I cleaned off any excess. The final stage of the refresh involved stripping off the old discoloured silicone from around the bath and replacing it with fresh silicone.
The customer was very impressed by the speed and efficiency of the refresh. With the work completed to a high standard in just a few hours, she now has one less problem to worry about – and a very smart looking shower cubicle! Another satisfied customer.
Source: Bathroom Tile and Grout Restoration in Edinburgh
We commonly encounter customers who are struggling to keep their Ceramic tiled shower cubicles clean. Since most people use their showers every day, the tiles and grout inevitably come into contact with shampoos and soaps that can cause staining, discolouration and mould. In fact, it’s not uncommon for property owners to completely give up on trying to clean the tiles, especially as many everyday cleaners are ineffectual, and this allows the situation to worsen over time.
This customer, who lives in Hale Village – known to be one of the UK’s quietest and best kept villages despite being just outside the busy city of Liverpool – was fed up with the state of her tiled shower cubicle and decided to seek professional assistance. I explained that with regular maintenance using suitable products, the tiles could be easily kept clean. I visited the property to show her first hand the results that could be achieved by cleaning and recolouring the grout.
Grout Cleaning and Recolouring Ceramic Bathroom Tiles
The ideal product for cleaning grout that has become affected by mould is Tile Doctor Mould Away, a fast and effective formula that can be directly applied. After applying the Mould Away I allowed it to soak into the grout for 20 minutes, before scrubbing it in with a special handheld brush. I also scrubbed it into the tiles to remove any excess staining caused by coming into contact with shampoos and soaps.
After completing a thorough clean of both the grout and tiles, it was time to remove the old silicone sealant from around the edges of the bath, and replace it with a fresh white sealant. I then opted to recolour the grout to match it with the tiles and the new sealant, doing so carefully with Tile Doctor’s own White Grout Colourant. This is just one of ten different Grout Colourant options we offer. Other options include Charcoal Grey, Black and Cappuccino Brown to much different colour tiles.
The combination of cleaning and recolouring completely refreshed the appearance of this Ceramic tiled shower cubicle, to the point that it almost looks new. Needless to say my customer was very happy, and can see now just how easy it can be to keep these tiles looking good using the right products.
Professional Bathroom Tile and Grout Cleaning in Cheshire