Renovating a Family Shower Cubicle in a Sheffield Suburb

We were contacted by a family from Hillsborough, which is a suburb of Sheffield, who had seen some of the work we do renovating shower cubicles on the internet and wanted to know if I would do the same for their shower.

Ceramic Shower Tile and Grout Before Revamp Sheffield Ceramic Shower Tile and Grout Before Revamp Sheffield

One of the biggest problems affecting bathrooms is mould which thrives in a warm damp environment, the best way to prevent it is to extract the moisture created when having a shower with adequate ventilation. Other steps you can take to reduce mould include always leaving the door open after a shower to improve cross ventilation and rinsing the shower down with cold water afterwards. Tile Doctor also have a product called Aqua-Pro that you can spray on your tiles after use.

I went over to take a look and could see that the Ceramic tiles were only slightly stained and would no doubt clean-up easily however the grout had gone black in places with mould and orange in others due to the dyes in shampoos and soaps. Ceramic tiles are glazed and so usually very easy to keep clean however grout and silicone is more vulnerable and if you now cleaned on a regular basis mould can get a grip and it can prove very stubborn to remove.

Ceramic Shower Tile and Grout Before Revamp Sheffield

Cleaning Ceramic Bathroom Tile and Grout

The home owners had tried to rectify the problem before by applying more grout and silicone to the affected areas however this hadn’t cured the ventilation issue, so it wasn’t long before the problem resurfaced. I recommended replacing all the badly affected grout and the silicone sealer strip around the base of the shower to give the cubicle a fresh look.

My first task was to see how far we could get by cleaning the tile and grout using Tile Doctor Duo-Clean which is designed for use in bathrooms where it’s effective at cleaning grout and removing mould. It comes in a spray bottle so it’s just a question of spraying it onto the tile, grout and silicone and leaving it for ten minutes before scrubbing it in with a stiff brush or scouring pad. The soil was then rinsed off the tile and grout and the shower left to dry off for a while, so we could see which areas were so badly stained would need re-grouting.

The next step was to carefully remove the old silicone sealant from around the edges of the shower cubicle using a sharp knife, then using a combination of power tools and blades we removed the grout in the affected areas and put in new white grout to match the exiting.

While the grout was drying, the shower tray was cleaned up and new silicone sealant has added around the base of the shower cubicle using a premium mould resistant silicone that should be more resistant to staining.

Ceramic Shower Tile and Grout After Revamp Sheffield

The combination of cleaning and grout replacement worked a treat and the shower looks like a brand-new installation. This doesn’t resolve the ventilation issue, so I left the customer with a bottle of Tile Doctor Aqua-Pro with instructions to spray the tiles down regularly in order to keep it looking fresh and clean.

Ceramic Shower Tile and Grout After Revamp Sheffield Ceramic Shower Tile and Grout After Revamp Sheffield

 

Source: Shower Tile Cleaning and Renovation Service in Hillsborough, South Yorkshire

Deep Cleaning Shower Tile Grout in Cumbria

We were asked to look at a renovating a bathroom shower at a house at the The Green, near Millom which was rather useful as it is a short distance from my own home. Millom is a small town in South West Cumbria that actually dates to 1251 when it was given a market charter by King Henry III.

Given the location it wasn’t long before I was able to pop round and review the shower installation. It was clear that the shower needed some Tile Doctor TLC, with mould being a major issue in the silicone seal and grout near the base of the shower.

Bathroom Shower Cubicle Before Renovation Millom

Mould thrives in warm damp environments such as shower cubicles and the problem can usually be traced to a lack of adequate ventilation. Improving the ventilation should resolve the problem permanently however if that’s not possible it can be controlled by regular use of products such as Tile Doctor Oxy-Pro shower cleaner or Tile Doctor Duo Clean which is a double action mould and grout cleaner. Other steps you can take include leaving the door open after a shower to improve cross ventilation and rinsing the shower down with cold water after a shower.

After reviewing the installation, we agreed on a price and I returned a few days later to carry out the work.

Cleaning Ceramic Bathroom Tile and Grout

On return the first thing we did was thoroughly clean the tile and grout using Tile Doctor Oxy-Gel, our high performance alkaline cleaner and de-greaser in gel form making light work of cleaning vertical tiled surfaces. The gel was scrubbed into all tile and grout surfaces and left to dwell for five minutes then thoroughly rinsed down with water. This process was repeated until we were happy with the result.

The next stage was to remove the mould riddled silicon and small areas of damaged grout at the base of the shower unit. This took some time to achieve as the silicon was in a very poor state. Once all traces of the silicone were removed we cleaned the area with more Oxy-Gel and carefully rinsed all the residues to stop us having any problems when re-applying new silicone.

Bathroom Shower Cubicle During Renovation Millom

The shower tray was cleaned of debris and a heat gun was used to completely dry all areas.

Replacing Shower Grout and Silicone Sealant

Finally, with the mould removed it was clear that a few areas of grout were crumbling and needed replacing. The old grout was raked out and a new batch of mould resistant grout was prepared and applied. Whilst that was drying I also replaced the silicone sealant between the shower tray and tile using a mould resistant silicone.

Bathroom Shower Cubicle After Renovation Millom

We asked the customer to not use the shower for at least 24 hours and as can be seen in the photographs the shower appearance was vastly improved. The customer is very pleased commenting that “it looks like new”.

Bathroom Shower Cubicle After Renovation Millom

 
 
Source: Tile and Grout Cleaning and Restoration Service in Cumbria

Renovating Three Shower Cubicles at Property in Sale, Cheshire

The photographs below are from one of three shower cubicles we were asked to clean and restore at a modernised Victorian property in SALE Cheshire. Ceramic tiles are glazed so very easy to keep clean, grout and silicone however are not and if you let mould build-up untreated it can very difficult to remove.

Mould likes a warm damp environment which can be reduced by improving the ventilation in the shower room, other steps you can take to reduce mould include always leaving the door open after a shower to improve cross ventilation and rinsing the shower down with cold water after a shower. Tile Doctor also have a product called Oxy-Pro that you can spray on your tiles after use.

Shower Cubicle Before Cleaning in Sale Shower Cubicle Before Cleaning in Sale

Sale is a town in Trafford, Greater Manchester but is historically part of Cheshire and dates to before the Middle Ages. A survey commissioned by the Royal Mail in 2017 highlighted Sale as the 4th most desirable town in England to live in and being so close to the city of Manchester makes it a popular choice for commuters.

Cleaning Ceramic Bathroom Tile and Grout

To get the grout clean Tile Doctor Pro-Clean was decanted into a spay bottle diluted with water and the solution was sprayed onto the grout lines. Pro-Clean in a strong and effective grout cleaner and after leaving it in place for about five minutes it was scrubbed in by hand using a stiff brush along the grout lines. I also gave the tile and cubicle glass a clean with Tile Doctor Oxy-Pro which comes in a ready to use spray bottle.

The next step was to carefully remove the old silicone sealant from around the edges of the shower cubicle using a sharp knife, so it could be replaced with new.

At this stage I took a step back to review the results of the cleaning, I wanted the best possible outcome for my customer and if more work was needed to get the shower looking it’s best now was the time. I concluded that the grout was much improved by unfortunately the mould staining was still visible in areas and that the best way to proceed would be to colour the grout.

Colouring Shower Tile Grout

Tile Doctor have a Grout Colourant product that’s available in ten different colours including White which I felt would be the best colour for the cubicle. Other colours include three shades of Grey, two shades of Brown and two shades of Beige as well as Black. The Grout Colourant is painted onto the grout lines using a small brush and I find a toothbrush works well for this purpose. Excess colourant needs to be removed from the tile before it sets, and I often find baby wipes work well for this purpose.

The grout colourant adds an epoxy barrier over the grout that is resistant to staining and much easier to clean than the grout itself. With this in place the grout will stay protected and the cubicle should keep its appearance for some time to come.

While the Grout Colourant was drying I replaced the silicone around the base of the shower cubicle using a premium mould resistant silicone that should be more resistant to staining.

Once the colourant and silicone had dried I gave the cubicle a final inspection and buffed up the ceramic tiles with a six-inch white pad fitted to a handheld buffer. As I mentioned before there were three shower cubicles to complete so as one was drying I was able to move onto another and as a result managed to complete all three in one day.

Shower Cubicle After Cleaning in Sale Shower Cubicle After Cleaning in Sale

 
 
Source: Shower Tile Cleaning and Renovation Service in Cheshire